Installing Storage Media In A Supervisor Module - Cisco Nexus 7000 Hardware Installation And Reference Manual

Chapter 3 Installing a Cisco Nexus 7009 Chassis
Swing the door closed so that the unused hinge pins fit inside the slots on the top and bottom of the door.
Step 14
When you close the door, the door stopper automatically presses the lock button on the inside of the door
so that the door is locked on the hinge pins. If the door stopper does not close the latches, press the door
closed at the handle until you hear the latches click. Make sure that the door is fully secured to the frames
on both sides.
If a hinge pin is not secured behind a door latch, open the door handle for that side of the door until it
Note
clicks, open that side of the door, and then press the door closed so that the pins are positioned all the
way inside the door slots. When you close the door, the door stopper automatically closes the door
latches. If you do not hear the latches click, press the door at the handle to fully close it and to activate
the latches. Test the door to make sure that it is fully secured to the four hinge pins.
Whenever you need to open the door, pull one of the door handles open until it clicks and then swing
Tip
that side of the door open.

Installing Storage Media in a Supervisor Module

Each supervisor module on a Cisco Nexus 7000 Series switch is shipped with a CompactFlash card
installed in the LOG FLASH reader (Supervisor 1 modules) or a USB drive installed in the LOG FLASH
reader (Supervisor 2 and Supervisor 2E modules). The EXPANSION FLASH reader (Supervisor 1) or
Slot0 port (Supervisor 2 and 2E) is left empty, but you can optionally install a card in that reader or a
USB drive in the USB port. To allow this storage media to function with the reader or port, you must
make sure that it is either formatted for the reader before installing it or format it after installing it.
Note The LOG FLASH and EXPANSION FLASH or Slot0 readers require different formats for their storage
media.
To replace an installed CompactFlash card, see the
section on page
To install storage media in a supervisor module, follow these steps:
Align the storage media to its slot or port on the supervisor module as follows:
Step 1
•
OL-23069-07
10-59.
For a Supervisor 1 module, align the card with the slot for the CompactFlash reader slot labeled
LOG FLASH or EXPANSION FLASH as shown in
card are on the end of the card that goes into the reader first. If the card does not fit easily into the
reader, flip the card so that the bottom edge is on top, and try pushing the card into the reader.
Installing Storage Media in a Supervisor Module
"Replacing Storage Media for a Supervisor Module"
Figure
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
3-26. The grooves on the thin side of the
3-35