Appendix E
Repacking the Cisco Nexus 7000 Series Switch for Shipment
Lower the chassis to the level of the pallet or no more than 0.25 inches (0.6 cm) above the pallet.
Step 18
Caution
You need two persons for the following step.
Step 19
Use at least two persons to push the chassis onto the raised portion of the pallet. Position the chassis so
that it is 4 inches (10.2 cm) away from the side of the common edge of the pallet and its raised portion.
Attach two angle brackets to the raised portion of the pallet between the chassis and the pallet edge. Do
Step 20
not tighten the screws that hold these brackets to the pallet—you will need to adjust their placement after
you place the chassis on the pallet. See
Figure E-32
1
Lower pallet
2
Raised portion of the pallet
3
Mounting brackets (two shown and two are on
the other side of the chassis)
OL-23069-07
Figure
Attaching the Chassis to the Shipping Pallet
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Repacking the System Components
E-32.
4
Bolts holding brackets to the upper pallet
5
Screws holding the chassis to the brackets
E-49