Installing The Cable Management Frames - Cisco Nexus 7000 Hardware Installation And Reference Manual

Chapter 2 Installing a Cisco Nexus 7004 Chassis
Prepare the other end of the grounding wire and connect it to an appropriate grounding point in your site
Step 5
to ensure an adequate earth ground for the switch. If the rack is grounded, connect the grounding wire
as explained in the documentation provided by the vendor for the rack.
Connecting Your ESD Wrist Strap to the Chassis
After you connect the chassis to the data center earth ground, you can ground your ESD wrist strap by
plugging it into the ESD port shown by Callout 2 in

Installing the Cable Management Frames

After you have fastened the chassis to the rack, you can fasten the cable management frames to the front
of the chassis.
To fasten the cable management frames to the chassis, follow these steps:
Align the guide guide pin on one of the two cable management frames to a guide-pin hole of the same
Step 1
size on the front-mounting bracket that is already attached to the chassis. The top of the frame should be
at the same level as the top of the chassis (see
OL-23069-07
Figure 2-4 on page
Figure 2-5).
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Installing the Cable Management Frames
2-10.
2-11