Cisco Nexus 7000 Hardware Installation And Reference Manual page 455

Appendix E Repacking the Cisco Nexus 7000 Series Switch for Shipment
Figure E-10
3
2
1 Box for the front door and air intake frame
2 Hinge bracket for the front door
3 Air-intake frame
4
Protective cardboard insert with slots
available for the hinge bracket and air-intake
frame
5
Small parts bag placed in open slot
Slide the air-intake frame and the hinge bracket inside separate slots of the protective cardboard
l.
insert (see Callouts 2, 3, and 4 in
box.
m. Place the small parts bag in the open slot of the cardboard insert (see Callout 5 in
n. Place the front door, which is wrapped in bubblewrap, inside the box (see callout 6 in
Fold the flaps of the box on top of the front door (see Callouts 7 and 8 in
o.
Secure the top two flaps together and to the box using packing tape (see Callout 9 in
p.
Remove and repack the cable management frames as follows:
Step 8
Remove the top cable management frame by unscrewing its four M4 screws (two on each side as
a.
shown in
accessory kit parts.
OL-23069-07
Repacking the Front Door and Air Intake Frame
1
Figure E-11) and pulling the frame off the chassis. Place the screws in a bag for small
6
5
4
8
7
6 Front door wrapped in bubble wrap
7 Shorter box flaps folded over the front door
8 Longer box flaps folded over the shorter flaps
9
Tape securing the box flaps together and to the
box
Figure E-10), and place the cardboard insert in the bottom of the
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Repacking the System Components
7
9
8
Figure E-10).
Figure
Figure E-10).
Figure
E-10).
E-10).
E-17