Installing Usb Storage Media In A Supervisor 2 Or 2E Module - Cisco Nexus 7000 Hardware Installation And Reference Manual

Installing USB Storage Media in a Supervisor 2 or 2E Module

Figure 2-5
1
Fasten the frame to the chassis with three M3 x 10 mm screws (see Callout 2 in
Step 2
screws to 5 to 7 in-lb (0.56 to 0.79 N.m).
Repeat Steps 1 and 2 to install the other cable management frame to the chassis.
Step 3
Installing USB Storage Media in a Supervisor 2 or 2E Module
Each Supervisor 2 or 2E module on a Cisco Nexus 7004 switch has a USB drive installed in the LOG
FLASH reader. The Slot0 port is left empty, but you can optionally install a USB drive in the that port.
To allow this storage media to function with the USB port, you must make sure that it is either already
formatted for the port before installing it or format it after installing it.
The LOG FLASH and Slot0 USB ports use different formats for their data.
Note
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
2-12
Installing the Cable Management Frames on a Cisco Nexus 7004 Chassis
Guide pins on the cable management
frame aligned to two holes in the
front-mount bracket.
Chapter 2 Installing a Cisco Nexus 7004 Chassis
2 Three M3 x 10 mm screws used to fasten the frame
to the chassis (total of six screws for two frames).
Figure 2-5). Tighten the
OL-23069-07