Replacing The Cable Management Frame On The Cisco Nexus 7018 Chassis; Required Tools; Removing The Cable Management Frame - Cisco Nexus 7000 Hardware Installation And Reference Manual

Replacing the Cable Management Frame on the Cisco Nexus 7018 Chassis

Replacing the Cable Management Frame on the Cisco Nexus
7018 Chassis
This section describes how to remove cable management frame components and install the components
for a replacement frame. The cable management frame includes two lower cable management
assemblies, two upper cable management assemblies, and a top cover.
This section includes the following topics:
•
•
•

Required Tools

You need a flat-blade or number 2 Phillips-head screwdriver to loosen or tighten the screws that hold the
cable management assemblies to the chassis.

Removing the Cable Management Frame

When you remove the cable management frame from the Cisco Nexus 7018 chassis, you must remove a
top cover and four cable management assemblies.
Before you can remove the cable management frame from the Cisco Nexus 7018 chassis, you must
Note
remove the front door and its bracket if they are installed on the cable management frame. For
information on removing the front door and its bracket, see the
Assemblies on the Cisco Nexus 7018 Chassis" section on page
To remove the cable management frame assemblies, follow these steps:
Step 1 Loosen and remove the eight M4x8 pan-head screws that fasten the top cover to the upper cable
management assemblies and chassis (see
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
10-72
Required Tools, page 10-72
Removing the Cable Management Frame, page 10-72
Installing a Cable Management Frame, page 10-76
Chapter 10
"Replacing the Front Door and Air Intake
10-81.
Figure 10-27).
Installing or Replacing Components
OL-23069-07