Required Tools; Installing The Front Door And Air Intake Frame - Cisco Nexus 7000 Series Hardware Installation And Reference Manual

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Installing a Cisco Nexus 7018 Chassis
This chapter describes how to install a new or relocated Cisco Nexus 7018 chassis in a rack or cabinet.
For information about installing a Cisco Nexus 7010 chassis, see
7010 Chassis."
chassis, see
This chapter includes the following sections:
•
•
•
•
•
•
•
Preparing to Install the Device
This section includes the following topics:
•
•
•
You must have one four-post, 19-inch EIA rack or cabinet before you can install the Cisco Nexus 7018
Note
chassis. Make sure that you order the rack or cabinet and have it delivered before installing the chassis.

Required Tools

Before you install the Cisco Nexus 7018 chassis into a rack, make sure that you have the following tools
and equipment:
•
•
OL-18634-01
For information about installing power supply units in the Cisco Nexus 7000 Series
Chapter 4, "Installing Power Supply Units."
Preparing to Install the Device, page 3-1
Installing the Bottom-Support Rails on the Rack, page 3-3
Installing the Chassis, page 3-6
Grounding the Cisco Nexus 7018 Chassis, page 3-11
Installing the Cable Management Assemblies, page 3-14
Installing the Front Door and Air Intake Frame, page 3-19
Installing and Formatting CompactFlash Cards, page 3-29
Required Tools, page 3-1
Installing a Four-Post Rack or Cabinet, page 3-2
Unpacking and Inspecting a New Chassis, page 3-3
Mechanical lift capable of lifting 700 lbs (318 kg)
No. 1 Phillips screwdriver with torque capability
C H A P T E R
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
3
Chapter 2, "Installing a Cisco Nexus
3-1