Cisco Nexus 7000 Hardware Installation And Reference Manual page 80

Installing the Chassis
To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using the
Warning
handles on modules (such as power supplies, fans, or cards); these types of handles are not designed
to support the weight of the unit. Statement 1032
Caution To lift the chassis, use a mechanical lift. Use the handles on the side of the chassis for only repositioning
the chassis after it is already on the mechanical lift or in the rack or cabinet.
Use the mechanical lift to move and align the rear of the chassis to the front of the rack or cabinet. Make
Step 3
sure that the bottom of the chassis is elevated to the height of the bottom-support rails or no more than
0.25 inch (0.635 cm) above the bracket.
Use at least two persons to push the chassis onto the installed bottom-support rails until the front-mount
Step 4
brackets come in contact with the rack rails. Push the lower half of the front side of the chassis so that
the back side enters the rack first, and push until the chassis vertical front-mounting brackets or
center-mounting brackets come in contact with the front of the rack. (See
Figure 3-9
1 Push the lower half of the front side of the chassis 3
2
Center-mount brackets
Make sure that the screw holes in the chassis mounting brackets align with the screw holes in the vertical
Step 5
mounting rails.
To adjust the placement of the chassis so that the screw holes in the chassis mounting brackets align with
Tip
the screw holes in the vertical mounting rails, use the chassis handles shown in
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
3-18
Moving a Cisco Nexus 7009 Chassis onto a Rack (Center-Mount Installation)
Chapter 3 Installing a Cisco Nexus 7009 Chassis
Figure 3-9.)
Rack with vertical mount rails
Figure 3-6.
OL-23069-07