Installing A Cable Management Frame - Cisco Nexus 7000 Hardware Installation And Reference Manual

Replacing the Cable Management Frame on the Cisco Nexus 7018 Chassis

Installing a Cable Management Frame

When you install a cable management frame, you attach four cable management assemblies to the
chassis and then attach a top cover to the top two cable management assemblies and the chassis.
To install the cable management frame on the Cisco Nexus 7018 switch chassis, follow these steps:
Open the Cable Management kit (69-1961-01) and verify that you have the following parts:
Step 1
•
•
•
•
•
If the kit is not complete, contact TAC and arrange for a complete kit.
Step 2 Attach a lower cable management assembly onto the two hooks that protrude from the lower half of the
left rack-mount bracket that is attached to the Cisco Nexus 7018 switch chassis, and loosely fasten the
assembly to the chassis with four flat-head M4x10 screws as shown in
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
10-76
2 lower cable management assemblies (800-31343-01)
2 upper cable management assemblies (800-31342-01)
1 top cover (800-31269-01)
8 M4x8 pan-head screws (48-0398-01)
18 M4x10 flat-head screws (48-2518-01)
Chapter 10 Installing or Replacing Components
Figure 10-30.
OL-23069-07