Wan Status - NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall Reference Manual

Table C-9. System Logs: Unicast, Redirect (continued)
Recommended Action To enable these logs, from the CLI command prompt of the router, enter this
Multicast/Broadcast Logs
Table C-10. System Logs: Multicast/Broadcast
Message
Explanation
Recommended Action None

WAN Status

This section describes the logs generated by the WAN component. If there are several ISP links for
Internet connectivity, the VPN firewall can be configured either in auto-rollover or load balancing
mode.
Load Balancing
When the WAN mode is configured for load balancing, all the WAN ports are active
simultaneously and the traffic is balanced between them. If one WAN link goes down, all the
traffic is diverted to the other WAN links that are active.
This section describes the logs generated when the WAN mode is set to load balancing.
Table C-11. System Logs: WAN Status, Load Balancing
Message
System Logs and Error Messages
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
command:
monitor/firewallLogs/logger/loggerConfig logIcmpRedirect 1
And to disable it enter:
monitor/firewallLogs/logger/loggerConfig logIcmpRedirect 0
Jan 1 07:24:13 [SRX5308] [kernel] MCAST-BCAST IN=WAN OUT=SELF
SRC=192.168.1.73 DST=192.168.1.255 PROTO=UDP SPT=138 DPT=138
• This packet (Broadcast) is sent to the device from the WAN network.
• For other settings, see
Dec 1 12:11:27 [SRX5308] [wand] [LBFO] Restarting WAN1_
Dec 1 12:11:31 [SRX5308] [wand] [LBFO] Restarting WAN2_
Dec 1 12:11:35 [SRX5308] [wand] [LBFO] WAN1(UP), WAN2(UP)_
Dec 1 12:24:12 [SRX5308] [wand] [LBFO] WAN1(UP), WAN2(DOWN)_
Dec 1 12:29:43 [SRX5308] [wand] [LBFO] Restarting WAN2_
Dec 1 12:29:47 [SRX5308] [wand] [LBFO] WAN1(UP), WAN2(DOWN)_
v1.0, April 2010
Table C-1.
C-5