NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall Reference Manual page 140

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
Figure 4-29
2. Below Add Port Triggering Rule, enter the settings as explained in
Table 4-11. Port Triggering Settings
Setting
Name
Enable
Protocol
Outgoing (Trigger)
Port Range
Incoming (Response)
Port Range
3. Click the Add table button. The new port triggering rule is added to the Port Triggering Rules
table.
4-50
Description (or Subfield and Description)
A descriptive name of the rule for identification and management purposes.
From the drop-down list, select Yes to enable the rule. (You can define a rule but
not enable it.) The default setting is No.
From the drop-down list, select the protocol to which the rule applies:
• TCP. The rule applies to an application that uses the Transmission Control
Protocol (TCP).
• UDP. The rule applies to an application that uses the User Control Protocol
(UCP).
Start Port The start port (1–65534) of the range for triggering.
End Port The end port (1–65534) of the range for triggering.
Start Port The start port (1–65534) of the range for responding.
End Port The end port (1–65534) of the range for responding.
v1.0, April 2010
Table 4-11.
Firewall Protection