NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall Reference Manual page 48

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
Figure 2-17
4. Configure the protocol binding settings as explained in
Table 2-6. Protocol Binding Settings
Setting Description (or Subfield and Description)
Service From the drop-down list, select a service or application to be covered by this rule. If
the service or application does not appear in the list, you must define it using the
Services screen (see
Local Gateway From the drop-down list, select one of the WAN interfaces.
Source Network The source network settings determine which computers on your network are affected
by this rule. Select one of the following options from the drop-down list:
Any
Single address
Address Range
Group 1–Group 8 If this option is selected, the rule is applied to the devices that are
2-24
Table
"Services-Based Rules" on page
All devices on your LAN.
In the Start IP field, enter the IP address to which the rule is
applied.
In the Start IP field and End IP field, enter the IP addresses for the
range to which the rule is applied.
assigned to the selected group.
Note: You can also assign a customized name to a group (see
"Changing Group Names in the Network Database" on page
Connecting the VPN Firewall to the Internet
v1.0, April 2010
2-6.
4-3).
3-18).