NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall Reference Manual page 95

Table 4-2. Outbound Rules Overview (continued)
Setting Description (or Subfield and Description)
Select Schedule The time schedule (that is, Schedule1, Schedule2, or Schedule3) that is used by this
rule.
• This drop-down list is activated only when "BLOCK by schedule, otherwise allow"
• Use the schedule screen to configure the time schedules (see
LAN Users The settings that determine which computers on your network are affected by this
rule. The options are:
• Any. All PCs and devices on your LAN.
• Single address. Enter the required address to apply the rule to a single device on
• Address range. Enter the required addresses in the Start and End fields to apply
• Groups. Select the group to which the rule applies. Use the LAN Groups screen
WAN Users The settings that determine which Internet locations are covered by the rule, based
on their IP address. The options are:
• Any. All Internet IP address are covered by this rule.
• Single address. Enter the required address in the Start field.
• Address range. Fill in the Start and End fields.
DMZ Users The settings that determine which DMZ computers on the DMZ network are affected
by this rule. The options are:
• Any. All PCs and devices on your DMZ network.
• Single address. Enter the required address to apply the rule to a single PC on the
• Address range. Enter the required addresses in the Start and End fields to apply
QoS Profile The priority assigned to IP packets of this service. The priorities are defined by "Type
of Service (ToS) in the Internet Protocol Suite" standards, RFC 1349. The QoS
profile determines the priority of a service, which, in turn, determines the quality of
that service for the traffic passing through the firewall.
The VPN firewall marks the Type of Service (ToS) field as defined in the QoS profiles
that you create. For more information, see
Profiles" on page
Note: There is no default QoS profile on the VPN firewall. After you have created a
QoS profile, it can become active only when you apply it to a non-blocking inbound or
outbound firewall rule.
Note: This field is not applicable to LAN DMZ rules.
Firewall Protection
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
or "ALLOW by schedule, otherwise block" is selected as the Action.
to Block or Allow Specific Traffic" on page
your LAN.
the rule to a range of devices.
(under Network Configuration) to assign PCs to groups. See
and Hosts (LAN Groups)" on page
DMZ network.
the rule to a range of DMZ computers.
4-34.
v1.0, April 2010
4-40).
3-14.
"Creating Quality of Service (QoS)
"Setting a Schedule
"Managing Groups
4-5