NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall Reference Manual page 37

6. If your connection is PPTP or PPPoE, your ISP requires an initial login. Enter the settings as
explained in Table
Table 2-2. PPTP and PPPoE Settings
Setting Description (or Subfield and Description)
Austria (PPTP) If your ISP is Austria Telecom or any other ISP that uses PPTP for login, select this
radio button and enter the following settings:
Account Name
Domain Name
Idle Timeout
My IP Address
Server IP
Address
Other (PPPoE) If you have installed login software, then your connection type is PPPoE. Select this
radio button and enter the following settings:
Account Name
Domain Name
Idle Timeout
Connection
Reset
Connecting the VPN Firewall to the Internet
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
2-2.
The account name is also known as the host name or system name.
Enter the valid account name for the PPTP connection (usually your
email "ID" assigned by your ISP). Some ISPs require you to enter
your full email address here.
Your domain name or workgroup name assigned by your ISP, or
your ISP's domain name. You can leave this field blank.
Select the Keep Connected radio button to keep the connection
always on. To log out after the connection is idle for a period of time,
select the Idle Time radio button and, in the timeout field, enter the
number of minutes to wait before disconnecting. This is useful if your
ISP charges you based on the period that you have logged in.
The IP address assigned by the ISP to make the connection with the
ISP server.
The IP address of the PPTP server.
The valid account name for the PPPoE connection.
The name of your ISP's domain or your domain name if your ISP
has assigned one. You can leave this field blank.
Select the Keep Connected radio button to keep the connection
always on. To log out after the connection is idle for a period of time,
select the Idle Time radio button and, in the timeout field, enter the
number of minutes to wait before disconnecting. This is useful if your
ISP charges you based on the period that you have logged in.
Select the Connection Reset check box to specify a time when the
PPPoE WAN connection is reset, that is, the connection is
disconnected momentarily and then reestablished. Then enter the
following settings:
Disconnect
Time
Delay
v1.0, April 2010
Specify the hour and minutes when the connection
should be disconnected.
Specify the period in seconds after which the
connection should be reestablished.
2-13