NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall Reference Manual page 155

3. Enter the settings as explained in
Table 5-4. Security Policy Editor: Remote Party Settings
Setting
Connection Security Select the Secure radio button. If you want to connect manually only, select the
ID Type
Subnet
Mask
Protocol
Use
ID Type
4. Click the disk icon to save the configuration, or select File > Save from the Security Policy
Editor menu.
Virtual Private Networking Using IPsec Connections
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
Table
Description (or Subfield and Description)
Only Connect Manually check box.
From the drop-down list, select IP Subnet.
Enter the LAN IP subnet address of the VPN firewall that is displayed on the VPN
firewall's VPN Policies screen (see
the subnet address is 192.168.1.0.
Enter the LAN IP subnet mask of the VPN firewall that is displayed on the VPN
firewall's VPN Policies screen (see
the subnet mask is 255.255.255.0.
From the drop-down list, select All.
Select the Use check box. Then, from the drop-down list, select Secure Gateway
Tunnel.
Left drop-down list
Right drop-down list
v1.0, April 2010
5-4.
Figure 5-10 on page
Figure 5-10 on page
From the left drop-down list, select Domain Name. Then,
below, enter the local FQDN that you entered on the VPN
firewall's VPN Wizard screen (see
5-9). In this example, the domain name is srx_local1.com.
From the right drop-down list, select Gateway IP
Address. Then, below, enter the IP address of the WAN
interface that you selected on the VPN firewall's VPN
Wizard screen (see Figure 5-9 on page
example, the WAN IP address is 99.180.226.101.
Note: You can find the WAN IP address on the
Connection Status screen for the selected WAN port. For
more information, see
Status" on page 9-21.
5-11). In this example,
5-11). In this example,
Figure 5-9 on page
5-9). In this
"Viewing the WAN Port Connection
5-13