NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall Reference Manual page 283

2. Enter the settings as explained in
Table 9-2. E-mail and Syslog Settings
Setting
Log Options
Log Identifier
Routing Logs
From the Accepted Packets and Dropped Packets columns, select check boxes to specify which traffic
is logged:
• LAN to WAN
• LAN to DMZ
• DMZ to WAN
• WAN to LAN
• DMZ to LAN
• WAN to DMZ
System Logs
Select the check boxes to specify which system events are logged:
• Change of Time by NTP. Logs a message when the system time changes after a request from an
NTP server.
• Login Attempts. Logs a message when a login is attempted. Both successful and failed login
attempts are logged.
• Secure Login Attempts. Logs a message when a secure login is attempted. Both successful and
failed secure login attempts are logged.
• Reboots. Logs a message when the VPN firewall has been rebooted through the Web Management
Interface. (No message is logged when the reset button has been pushed to reboot the VPN firewall.)
• All Unicast Traffic. All incoming unicast packets are logged.
• All Broadcast/Multicast Traffic. All incoming broadcast and multicast packets are logged.
• WAN Status. WAN link status–related events are logged.
• Resolved DNS Names. All resolved DNS names are logged.
• VPN. All VPN events are logged.
Other Event Logs
Source MAC Filter
Session Limit
Bandwidth Limit
Monitoring System Access and Performance
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
Table
Description (or Subfield and Description)
Enter the name of the log in the Log Identifier field. The Log Identifier is a
mandatory field used to identify which device sent the log messages. The
identifier is appended to the log messages. The default identifier is SRX5308.
Select this check box to log packets from MAC addresses that match the source
MAC address filter settings (see
Select this check box to log packets that are dropped because the session limit
has been exceeded (see
Select this check box to log packets that are dropped because the bandwidth limit
has been exceeded (see
v1.0, April 2010
9-2.
"Enabling Source MAC Filtering" on page
"Setting Session Limits" on page
"Creating Bandwidth Profiles" on page
4-44).
4-29).
4-37).
9-7