NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall Reference Manual page 147

Figure 5-5
3. Select the radio buttons and complete the fields and as explained
Table 5-2. (IPsec) VPN Wizard Settings for a Gateway-to-Gateway Tunnel
Setting
About VPN Wizard
This VPN tunnel will connect
to the following peers
Connection Name and Remote IP Type
What is the new Connection
Name?
What is the pre-shared key?
This VPN tunnel will use
following local WAN Interface:
Virtual Private Networking Using IPsec Connections
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
Description (or Subfield and Description)
Select the Gateway radio button. The local WAN port's IP address or
Internet name appears in the End Point Information section of the
screen.
Enter a descriptive name for the connection. This name is used to help
you to manage the VPN settings; the name is not supplied to the
remote VPN endpoint.
Enter a pre-shared key. The key must be entered both here and on the
remote VPN gateway. This key must have a minimum length of
8 characters and should not exceed 49 characters.
From the drop-down list, select one of the four WAN interfaces of the
VPN firewall to specify which WAN interface the VPN tunnel uses as
the local endpoint.
v1.0, April 2010
Table 5-2.
5-5