Viewing the VPN Firewall IPsec VPN Connection Status
To review the status of current IPsec VPN tunnels:
Select VPN > Connection Status from the menu. The VPN Connection Status submenu tabs
display, with the IPSec VPN Connection Status screen in view.
an example.)
Figure 5-18
The Active IPSec SAs table lists each active connection with the information that is described in
Table 5-8 on page
5-19. The default poll interval is 5 seconds. To change the poll interval period,
enter a new value in the Poll Interval field, and then click Set Interval. To stop polling, click
Stop.
Table 5-8. IPsec VPN Connection Status Information
Item
Description (or Subfield and Description)
Policy Name
The name of the VPN policy that is associated with this SA.
Endpoint
The IP address on the remote VPN endpoint.
Tx (KB)
The amount of data that is transmitted over this SA.
Tx (Packets)
The number of IP packets that are transmitted over this SA.
State
The current status of the SA. Phase 1 is the authentication phase and Phase 2 is
key exchange phase. If there is no connection, the status is IPsec SA Not
Established.
Action
Click the Connect table button to build the connection, or click the Disconnect
table button to terminate the connection.
Virtual Private Networking Using IPsec Connections
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
v1.0, April 2010
(Figure 5-18
shows an IPsec SA as
5-19