NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall Reference Manual page 175

4. Complete the fields, select the radio buttons and check boxes, and make your selections from
the drop-down lists as explained
Table 5-12. Add VPN Policy Settings
Item
General
Policy Name
Policy Type
Select Local Gateway
Remote Endpoint
Enable NetBIOS?
Enable RollOver?
Virtual Private Networking Using IPsec Connections
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
Table 5-12.
Description (or Subfield and Description)
A descriptive name of the VPN policy for identification and management
purposes.
Note: The name is not supplied to the remote VPN endpoint.
From the drop-down list, select one of the following policy types:
• Auto Policy. Some settings (the ones in the Manual Policy Parameters
section of the screen) for the VPN tunnel are generated automatically.
• Manual Policy. All settings must be specified, including the ones in the
Manual Policy Parameters section of the screen.
From the drop-down list, select one of the four WAN interfaces to function as
the local gateway.
Select a radio button to specify how the remote endpoint is defined:
• IP Address. Enter the IP address of the remote endpoint in the fields to
the right of the radio button.
• FQDN. Enter the FQDN of the remote endpoint in the field to the right of
the radio button.
Select this check box to allow NetBIOS broadcasts to travel over the VPN
tunnel. For more information about NetBIOS, see
Bridging with IPsec VPN" on page
If you have configured the VPN firewall to function in WAN auto-rollover
mode (see "Configuring the Auto-Rollover Mode and Failure Detection
Method" on page
the corresponding drop-down list, select the backup WAN interface. After an
auto-rollover has occurred, the VPN tunnel will be reestablished using the
backup WAN interface. This feature is disabled by default.
v1.0, April 2010
5-59. This feature is disabled by default.
2-18), select the Enable RollOver? check box. Then, from
"Configuring NetBIOS
5-33