NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall Reference Manual page 194

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
Table 5-17. Security Policy Editor: Remote Party, Mode Config Settings (continued)
Setting
Protocol
Use
ID Type
4. Click the disk icon to save the configuration, or select File > Save from the Security Policy
Editor menu.
5-52
Description (or Subfield and Description)
From the drop-down list, select All.
Select the Use check box. Then, from the drop-down list, select Secure
Gateway Tunnel.
Left drop-down list
Right drop-down list
Virtual Private Networking Using IPsec Connections
v1.0, April 2010
From the left drop-down list, select Domain Name.
Then, below, enter the local FQDN that you specified
in the VPN firewall's Mode Config IKE policy. In this
example, we are using srx_local2.com.
From the right drop-down list, select Gateway IP
Address. Then, below, enter the IP address of the
WAN interface that you selected on the VPN firewall's
VPN Wizard screen (see
this example, the WAN IP address is 99.180.226.101.
Note: You can find the WAN IP address on the
Connection Status screen for the selected WAN port.
For more information, see
Connection Status" on page
Figure 5-9 on page 5-9). In
"Viewing the WAN Port
9-21.