NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall Reference Manual page 172

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
2. Click the VPN Policies submenu tab. The VPN Policies screen displays.
some examples.)
Figure 5-22
Each policy contains the data that are explained in
more detail in Table 5-12 on page
Table 5-11. List of VPN Policies Information
Item
! (Status)
Name
Type
Local
Remote
5-30
5-33.
Description (or Subfield and Description)
Indicates whether the policy is enabled (green circle) or disabled (gray circle). To
enable or disable a policy, select the check box adjacent to the circle and click
the Enable or Disable table button, as appropriate.
The name that identifies the VPN policy. When you use the VPN Wizard to
create a VPN policy, the name of the VPN policy (and of the automatically
created accompanying IKE policy) is the connection name.
Auto or Manual as described previously (Auto is used during VPN Wizard
configuration).
IP address (either a single address, range of addresses, or subnet address) on
your LAN. Traffic must be from (or to) these addresses to be covered by this
policy. (The subnet address is supplied as the default IP address when you are
using the VPN Wizard).
IP address or address range of the remote network. Traffic must be to (or from)
these addresses to be covered by this policy. (The VPN Wizard default requires
the remote LAN IP address and subnet mask.)
Virtual Private Networking Using IPsec Connections
v1.0, April 2010
Table 5-11. These fields are explained in
(Figure 5-22 shows