NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall Reference Manual page 289

Table 9-4. Detailed Status Screen Fields
Setting
LAN Port Configuration
The following fields are shown for each of the four LAN port.
VLAN Profile
VLAN ID
MAC Address
IP Address
Subnet Mask
DHCP Status
WAN Info
The following fields are shown for each of the four WAN port.
WAN Mode
WAN State
NAT
Monitoring System Access and Performance
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
Description (or Subfield and Description)
The name of the VLAN profile that you assigned to this port on the LAN Setup
screen (see "Assigning and Managing VLAN Profiles" on page
VLAN is not enabled on this port, the default profile (with VLAN ID 1) is
assigned automatically.
The VLAN ID that you assigned to this port on the Add VLAN Profile screen
(see "Configuring a VLAN Profile" on page
used, the VLAN ID is 1, which means that all tagged and untagged traffic can
pass on this port.
The MAC address of this port. All LAN ports share the same MAC address
(00:00:00:00:00:01). However, if LAN port 4 is enabled as the DMZ port, its
MAC address is changed to 00:00:00:00:00:06. For information about
configuring the DMZ port, see
page 3-20.
The IP address for this port. If the VLAN is not enabled on this port, the IP
address is the default LAN IP address (192.168.1.1). For information about
configuring VLAN profiles, see
The subnet mask for this port. If the VLAN is not enabled on this port, the
subnet mask is the default LAN IP subnet mask (255.255.255.0). For
information about configuring VLAN profiles, see
on page 3-6.
The status can be either DHCP Enabled or DHCP Disabled. For information
about enabling DHCP for this port, see
page 3-6.
The WAN mode can be Single Port, Load Balancing, or Auto Rollover. For
information about configuring the WAN mode, see
Mode" on page 2-16.
The WAN state can be either UP or DOWN, depending on whether the port is
connected to the Internet and whether the port is enabled. For information
about connecting WAN ports, see
page 2-7.
The NAT state can be either Enabled or Disabled, depending on whether NAT
is enabled (see "Configuring Network Address Translation" on page
classical routing is enabled (see
17).
v1.0, April 2010
3-6). If the default VLAN profile is
"Configuring and Enabling the DMZ Port" on
"Configuring a VLAN Profile" on page
"Configuring a VLAN Profile"
"Configuring a VLAN Profile" on
"Configuring the WAN
"Configuring the Internet Connections" on
"Configuring Classical Routing" on page 2-
3-3). If the
3-6.
2-16) or
9-13