NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall Reference Manual page 152

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
Table 5-3. (IPsec) VPN Wizard Settings for a Client-to-Gateway Tunnel
Setting
About VPN Wizard
This VPN tunnel will connect
to the following peers:
Connection Name and Remote IP Type
What is the new Connection
Name?
What is the pre-shared key?
This VPN tunnel will use
following local WAN Interface:
Enable RollOver
End Point Information
What is the Remote Identifier
Information?
What is the Local Identifier
Information?
Secure Connection Remote Accessibility
What is the remote LAN IP
Address?
What is the remote LAN
Subnet Mask?
a. Both local and remote endpoints should be defined as either FQDNs or IP addresses. A combination of an IP address and
an FQDN is not supported.
5-10
Description (or Subfield and Description)
Select the VPN Client radio button. The default remote FQDN
(srx_remote1.com) and the default local FQDN (srx_local1.com)
appear in the End Point Information section of the screen.
Enter a descriptive name for the connection. This name is used to help
you to manage the VPN settings; the name is not supplied to the
remote VPN endpoint.
Enter a pre-shared key. The key must be entered both here and on the
remote VPN gateway, or the remote VPN client. This key must have a
minimum length of 8 characters and should not exceed 49 characters.
From the drop-down list, select one of the four WAN interfaces of the
VPN firewall to specify which WAN interface the VPN tunnel uses as
the local endpoint.
If you have configured the VPN firewall to function in WAN auto-
rollover mode (see
Detection Method" on page
box. Then, from the corresponding drop-down list, select the backup
WAN interface. After an auto-rollover has occurred, the VPN tunnel will
be reestablished using the backup WAN interface.
a
When you select the Client radio button in the About VPN Wizard
section of the screen, the default remote FQDN (srx_remote1.com) is
automatically entered. Use the default remote FQDN or enter another
FQDN.
When you select the Client radio button in the About VPN Wizard
section of the screen, the default local FQDN (srx_local.1com) is
automatically entered. Use the default local FQDN or enter another
FQDN.
These fields are masked out for VPN client connections.
Virtual Private Networking Using IPsec Connections
v1.0, April 2010
"Configuring the Auto-Rollover Mode and Failure
2-18), select the Enable RollOver check