NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall Reference Manual page 20

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
The front panel also contains three groups of status indicator light-emitting diodes (LEDs),
including Power and Test LEDs, LAN LEDs, and WAN LEDs, all of which are explained in
Table 1-1.
Left LAN LEDs
Power LED
Test LED
Figure 1-1
Table 1-1. LED Descriptions
Object Activity
Power On (Green)
Off
Test On (Amber) during
startup.
On (Amber) during
any other time
Blinking (Amber)
Off
LAN Ports
Left LED On (Green)
Blink (Green)
Off
1-8
DMZ LED
Right LAN LEDs
Description
Power is supplied to the SRX5308.
Power is not supplied to the SRX5308.
Test mode: The SRX5308 is initializing. After approximately
2 minutes, when the SRX5308 has completed its initialization, the
Test LED goes off.
The initialization has failed or a hardware failure has occurred.
The SRX5308 is writing to flash memory (during upgrading or
resetting to defaults).
The system has booted successfully.
The LAN port has detected a link with a connected Ethernet device.
Data is being transmitted or received by the LAN port.
The LAN port has no link.
v1.0, April 20108
Left WAN LEDs
Right WAN LEDs
Internet
LEDs
Introduction