Navigating Cli Modes - Dell Force10 Z9000 Configuration Manual

ROUTER RIP
SPANNING TREE
TRACE-LIST
VLT DOMAIN
VRRP
UPLINK STATE GROUP
GRUB

Navigating CLI Modes

The Dell Networking OS prompt changes to indicate the CLI mode.
The following table lists the CLI mode, its prompt, and information about how to access and exit the CLI mode. Move linearly
through the command modes, except for the end command which takes you directly to EXEC Privilege mode and the exit
command which moves you up one command mode level.
NOTE: Sub-CONFIGURATION modes all have the letters "conf" in the prompt with more modifiers to identify the mode
and slot/port information.
Table 1. Dell Networking OS Command Modes
CLI Command Mode
EXEC
EXEC Privilege
CONFIGURATION
NOTE: Access all of the following
modes from CONFIGURATION
mode.
AS-PATH ACL
Gigabit Ethernet Interface
10 Gigabit Ethernet Interface
40 Gigabit Ethernet Interface
Interface Group
Interface Range
Loopback Interface
Management Ethernet Interface
Null Interface
Port-channel Interface
Tunnel Interface
VLAN Interface
32
Configuration Fundamentals
Prompt
Dell>
Dell#
Dell(conf)#
Dell(config-as-path)#
Dell(conf-if-gi-1/1)#
Dell(conf-if-te-0/0)#
Dell(conf-if-fo-0/0)#
Dell(conf-if-group)#
Dell(conf-if-range)#
Dell(conf-if-lo-0)#
Dell(conf-if-ma-0/0)#
Dell(conf-if-nu-0)#
Dell(conf-if-po-1)#
Dell(conf-if-tu-1)#
Dell(conf-if-vl-1)#
Access Command
Access the router through the console or
terminal line.
• From EXEC mode, enter the enable
command.
• From any other mode, use the end
command.
• From EXEC privilege mode, enter the
configure command.
• From every mode except EXEC and
EXEC Privilege, enter the exit
command.
ip as-path access-list
interface (INTERFACE modes)
interface (INTERFACE modes)
interface (INTERFACE modes)
interface(INTERFACE modes)
interface (INTERFACE modes)
interface (INTERFACE modes)
interface (INTERFACE modes)
interface (INTERFACE modes)
interface (INTERFACE modes)
interface (INTERFACE modes)
interface (INTERFACE modes)