Dot1X Command; Do Command; Enable Command - Planet GS-4210-24T4S User Manual

land-deny
nullscan-deny
pod-deny
smurf-deny
smurf-netmask
syn-sportl1024-deny
synfin-deny
synrst-deny
tcp-frag-off-min-check
tcpblat-deny
tcphdr-min-check
tcphdr-min-length
udpblat-deny
xma-deny

6.3.5 dot1x Command

Description:
802.1x configuration
Syntax:
dot1x guest-vlan<1-4094> VLAN ID (e.g. 100)

6.3.6 do Command

Description:
To run exec commands in current mode
Syntax:
do SEQUENCE (Exec Command)

6.3.7 enable Command

Description:
Local Enable Password
Syntax:
enable password/privilege/secret
Source IP equals to destination IP
NULL Scan Attacks
Ping of Death Attacks
Smurf Attacks
DoS information
SYN packets with sport less than 1024
SYN and FIN bits set in the packet
SYNC and RST bits set in the packet
TCP fragment packet with offset equals to one
Source TCP port equals to destination TCP port
Check minimum TCP header
DoS information
Source UDP port equals to destination UDP port
Xmascan: sequence number is zero and the FIN, URG and PSH bits are set
User's Manual of GS-4210 Series
377