Serial Control Device Startup - AMX Optima AVS-OP-1616-110 Instruction Manual

Installation & Setup

Serial Control Device Startup

If you have not already done so, attach the serial control device to the enclosure (see page 28) and open
the control program.
®
NetLinx
AMX AutoPatch Distribution Matrices are NetLinx
information, please contact your AMX representative.
APControl 3.0
If you are using APControl 3.0, install and open the program. Follow the directions in the setup wizard.
As part of the setup wizard, APControl will discover the system's configuration information. From the
Launchbar menu, select Views / CrossBar and click on the crosspoints to execute switches.
APWeb
For startup information, see the APWeb Server Module documentation.
HyperTerminal
When power is applied to the enclosure, HyperTerminal displays a one-line splash screen followed by
"Ready" (FIG. 16). The system is ready for a test switch (see page 37). If you need to see advanced
system information, enter ~scr! to view a long splash screen.
See FIG. 16 for an example of a short splash screen (your system's splash screen may differ). The short
splash screen provides the following information:
AMX AutoPatch Optima signal router
Host software: v3.1.0
Hardware driver: v0.0.11 R
Built on Jan 16 2008 12:31:53
XNet address: 0x0003.
Ready
FIG. 16
Power-up splash screen in HyperTerminal
Note: AMX reserves the right to add to the contents of the splash screen at any time, without notice.
36
Compatible
Host software – version of the initial operating system (IOS)
Hardware driver – the firmware version
Built – date the software was built
XNet address – enclosure's XNNet identification number
®
compatible. For specific control programming
Optima Instruction Manual