Changing The Proxy Setting - AMX Enova DGX 8 Instruction Manual

Changing the Proxy Setting

If the WebConsole does not open during setup, try the following troubleshooting strategies:





If the WebConsole still does not open, you may need to add an exception in the Proxy Setting dialog box.
The following instructions apply to Internet Explorer. To change these settings in another browser,
consult its Help file.
To add an exception to the proxy setting information:
1. From the Tools menu on the browser, select Internet Options.
The Internet Options dialog box opens.
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Check all power, signal, and link connections on all of the equipment.
Check LED indicators for the TCP/IP (RJ-45) connector on the Enova DGX enclosure.
If the LED indicators are not illuminated, check the cable type to make sure it meets cable
requirements (see page 41).
Ping the system, i.e., at the DOS prompt enter: ping XXX.XXX.XXX.XXX
(where XXX.XXX.XXX.XXX is the NXB-AP-1000 Interface IP address; see page 45).
Try connecting to the WebConsole again.
Firmware Upgrade & Info for Network Admin
149