Ip Control - Preferences - Enova Dgx 16 Preferences - AMX Enova DGX 8 Instruction Manual

IP Control - Preferences - Enova DGX 16 Preferences

When you select Preferences from the IP Control tab's drop-down menu, the Enova DGX 16 Preferences
page opens. This page allows you to customize the XBar Controller. The XBar, a cross-point controller,
is available from the IP Control drop-down menu; see page 142.
Options for customizing the XBar from Preferences page are:


FIG. 79
Enova DGX 16 Preferences page
Setting the Initial VM that will Display
Note: The virtual matrix (VM) for XBar Control can be changed at any time from VM title block.
The current VM (virtual matrix) is displayed in the VM title block in the upper left corner of the XBar.
The VM that initially displays in the VM title block is set at the factory to VM 0 (the default) unless the
system is ordered to do otherwise. To change a VM at any time, see Step 2 in the directions on page 144.
The default VM for executing switches that will display for all XBar Controllers that are launched for
the system can be specified from the Preferences page. The default VM is always the first VM listed on
the Enova DGX 16 Home page (access from the IP Control drop-down list).
If the XBar is open, close before using the following instructions. The "Enova DGX 16" option must be
selected in the Device drop-down list at the upper right of the WebConsole.
To set the initial virtual matrix that will display in the XBar Controller:
1.
From the IP Control drop-down menu, select Preferences.
2.
In the Initial VM Displayed field, enter the virtual matrix number.*
For example, the Enova DGX Switcher normally has two virtual matrices: VM 0 = all;
VM 1 = video.
3.
Click Accept.
The next time the XBar is launched, the newly designated default VM will display in the VM title
block and will be the first VM listed on the Enova DGX 16 Home page.
* If you want the default VM for display in the XBar to be the first virtual matrix discovered during
bootup regardless of its number, enter a value of -1; otherwise, enter the specific VM number.
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Setting the initial VM that will display in the VM title block
Setting the size of the XBar window
Enova DGX WebConsole Interface
141