AMX Enova DGX 8 Instruction Manual page 175

Troubleshooting Tip: If
program cannot read/write
EDID
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
To read and save EDID data:
1.
On the PC, open the DGX Configuration Software and select the EDID Programmer tab.
Messages
Read – reads EDID from selected output which received the EDID from its attached destination device
FIG. 94
EDID Programmer view
2.
From the Inputs/Outputs device tree on the left, select an output from which to read the EDID
information that it receives from the destination device.
3.
Click Read to read the EDID information. The results display in the large read-only area.
4.
From the File menu, select Save to File (select location, enter file name, and click Save).
Leave the EDID Programmer view open for using the instructions on writing the EDID to a
DGX Digital Media Switcher input connector on the next page.
Troubleshooting Tip: If the program cannot read and write the EDID information, the system may
not support all of the DGX Configuration Software functionality. From the Utilities menu, select
Launch EDID Programmer Classic to open a program that will work with the system; follow the
directions in its Help file.
Write – writes EDID to input on board
Appendix A – DGX Configuration Software
Device tree with Inputs/Outputs
EDID Information (read-only) –
data from file or from output
EDID Type (read-only) –
indicates digital or analog
Convert to Digital / Convert to Analog –
converts displayed EDID data
169