Epica Dgx Sc Optical Boards - Specifications - AMX Enova DGX 8 Instruction Manual

Epica DGX SC Optical Boards
Epica DGX SC Optical Boards – Specifications
Applies to input board FG1056-500 and output board FG1056-510.
Compatible AMX DGX Fiber Modules:




Note: Either Transmitter (TX) Module can be used with an SC Optical Input Board to route signals to
any of the output boards in the system. A signal with a compatible video format from any of the input
boards can be routed through an SC Optical Output board to a destination device via either Receiver
(RX) Module.
Epica DGX SC Optical Specifications
Parameter
Compatible AMX Products
Signal Types over Fiber
Resolution Support
Interlaced Resolution Support
Audio Support
Local Audio Support
Serial Data Support
Fiber Cable Type
Fiber Cable Length
Optical Budget
Fiber Input Board Propagation Delay
Fiber Output Board Propagation Delay
HDCP Support
Power Output of Laser Radiation (max.) 4.08 mW (SC Optical Output Board)
Safety Certifications
Fiber Connector
* 480i and 576i are only available when being transmitted from a DGX HD-15 TX as a Y-Pb-Pr signal.
** 96 kHz audio is only available when the source video resolution is 800x600 @ 60 Hz (40 MHz video pixel
clock) or greater. Otherwise 48 kHz is the maximum.
*** 3000 ft. cable requires 50/125 m OM2 class low loss fiber cable.
Important: These boards are compatible only with other AMX products that support the DGX Single
Fiber Technology. They are not compatible with third-party optical distribution amplifiers or
multimode to single-mode converters.
AMX reserves the right to modify its products and their specifications without notice.
96
FG1010-200-01 – AVB-TX-DGX-HD15-SC Fiber
FG1010-210-01 – AVB-TX-DGX-DVI-SC Fiber
FG1010-400-01 – AVB-RX-DGX-SC Fiber-HD15
FG1010-410-01 – AVB-RX-DGX-SC Fiber-DVI
Value
DGX HD-15 TX and RX, DGX DVI TX and RX;
other AMX DGX SC Fiber signal management products
Video, audio
Video signal must be present to pass audio
640x480 @ 60 Hz up to 1920x1200 @ 60 Hz
1080i 60, 59.94, 50 (fields per second)
576i 100, 50 (fields per second)*
480i 60 (fields per second)*
Analog stereo or S/PDIF (2CH L-PCM S/PDIF up to 96 kHz sample
rate**)
None
None
Multimode Simplex (with SC termination)
50/125 m (preferred) or 62.5/125 m
Up to 3000 ft. (914.4 m) in with 50 m cable***
Up to 3000 ft. (914.4 m) out with 50 m cable***
Up to 1500 ft. (457.2 m) in with 62.5 m cable
Up to 1500 ft. (457.2 m) out with 62.5 m cable
9.75 dBm (typical) between DGX TX and input board
9.75 dBm (typical) between output board and DGX RX
Optical Modulation Amplitude (OMA) Output: -6.25 dBm (typical)
Optical Modulation Amplitude (OMA) Input Sensitivity: -16.0 dBm
(typical)
1 s
2 s
No
Class 1 Laser Product (Class 3R Laser Product when fiber is
disconnected from the unit) IEC 60825-1, 2001
(SC Optical Output Board)
4 SC optical ports
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers