Epica Dgx Sc Optical Boards - AMX Enova DGX 8 Instruction Manual

Epica DGX SC Optical Boards

Applicability Notice
This chapter pertains to the following Epica DGX SC Optical Input and Output Boards which are
compatible in Enova DGX enclosures:


FIG. 50
Epica DGX SC Optical Boards, shown in an Enova DGX 32
Epica DGX SC Optical Boards have four input or output connectors per board.
Enova DGX 8
Enova DGX 8 enclosures can hold up to four Epica DGX SC Optical Boards. Each enclosure holds a
maximum of two input and two output boards, accommodating connector configurations up to a
maximum of 8x8, as well as three subsets (i.e., 4x4, 4x8, or 8x4).
Enova DGX 16
Enova DGX 16 enclosures can hold up to eight Epica DGX SC Optical Boards. Each enclosure holds a
maximum of four input and four output boards, accommodating connector configurations up to a
maximum of 16x16, as well as subsets (for example, 16x8 or 4x12).
Enova DGX 32
Enova DGX 32 enclosures can hold up to sixteen Epica DGX SC Optical Boards. Each enclosure holds
a maximum of eight input and eight output boards, accommodating connector configurations up to a
maximum of 32x32, as well as subsets (for example, 12x24 or 32x8).
Signal Routing
DGX SC Optical Input Boards route signals to DGX SC Optical Output Boards or to any other type of
Enova DGX Output Boards. DGX SC Optical Output Boards accept signals from all types of
Enova DGX Boards. These boards can be used for non-HDCP signals but do not support HDCP. When
routing signals between different board types, the Enova DGX Switcher automatically converts the
signal format to match the output board.
Important: Signals which are not supported are: HDCP, 3D formats, any other video signal above
1920x1200, Deep Color, and any audio signals originating in a format other than 2 channel PCM
digital or analog stereo audio. When HDCP protected video signals are routed through fiber, the
display provides a dark red image to indicate the authentication process failed. When compressed
audio signals are routed, the display goes blank. Non-HDCP signals are accepted.
Currently, the following signals can be sent over DGX SC Optical Boards: HDMI, DVI-D, analog video,
and digital or analog stereo audio. Supported analog video input signals include RGBHV, RGBS, RGsB,
and Y/Pb/Pr (converted to RGsB) and an RGBHV output signal.
DGX SC Optical Boards must be used in conjunction with DGX Fiber Modules (see the compatibility
list on the next page and the system setup information on page 97).
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
FG1056-500 Input board
FG1056-510 Output board
Epica DGX SC Optical Boards
95