Attaching Cables - AMX Enova DGX 8 Instruction Manual

Attaching Cables

Viewed from the rear of the enclosure, the input boards (for attaching sources) are on the left, and the
output boards (for attaching destinations) are on the right.
Enova DGX 8/16 – Input and output channel numbers correspond to the connectors and are located
between the input and output boards. For inputs, numbering is consecutive from left to right on each
board from the top board to the bottom one; outputs start over at 1 and follow the same pattern.
Enova DGX 32 – Input and output channel numbers correspond to the connectors and are located on the
numbering plate (metal strip) directly above the boards. For inputs, numbering is consecutive from top to
bottom on each board from the left board to right one; outputs start over at 1 and follow the same pattern.
Important: We strongly recommend screwing down the DVI connector retention screws to ensure
as good of a seating of the cable into the receptacle as possible.
To connect DVI inputs and outputs:
1.
Fasten the DVI-I (or DVI-D) connectors on the cable ends onto the DVI-I receptacles on the boards.
(For DVI pinout information, see below.)
FIG. 40
Fasten cables onto input and output connectors
DVI Pinout
Pinout information for the DVI-I connector on the DVI Input and Output Boards is listed in the chart in
FIG. 41.
FIG. 41
DVI-I connector pinout
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
DVI-I connector
DVI-I Pinout
1. Data 2- 9. Data 1-
2. Data 2+ 10. Data 1+
3. Ground 11. Ground
4. No connect 12. No connect
5. No connect 13. No connect
6. DDC-CLK 14. +5 V*
7. DDC-Data 15. Ground
8. No connect 16. Hot-Detect
* DVI output pin 14 (+5 VDC out) supplies 50 mA per each of the four output connectors.
Enova DGX DVI Boards
17. Data 0- C1. No connect
18. Data 0+ C2. No connect
19. Ground C3. No connect
20. No connect C4. No connect
21. No connect C5. No connect
22. Ground
23. CLK+
24. CLK-
77