Testing/Checking The Insert/Extract Functionality - AMX Enova DGX 8 Instruction Manual

Enova DGX Audio Insert/Extract Board
3.
Remove the screwdriver from the square hole so that the clamp places tension on the wire.
FIG. 62
Audio wiring for AIE Board
4. Test/check the Insert/Extract functionality (see below).

Testing/Checking the Insert/Extract Functionality

Insertion – If the DIP switch setting results in being inserted onto the corresponding video input or
output signal, execute a test switch using the video signal. If you need test switch details, see see
page 49.
Extraction – If the DIP switch setting results in audio being extracted from a video input or output
signal, check the auxiliary or supplemental audio equipment involved to be sure the audio signal is
present where expected.
If the system does not handle the audio in the expected manner, see AIE Board Troubleshooting on
page 109.
108
Enova DGX 32
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Tension clamp
Enova DGX 8/16
Tip: Insert a T-pin in each
of the 3 tension clamps on
one side before inserting wires.