Changing The Virtual Matrix - AMX Enova DGX 8 Instruction Manual

Control Panel Operation
2.
Press the Select Key to choose Change.
The system is in Change Mode (the available Input and Output Keys turn blue).
3.
Press Input Key 1.
Input Key 1 flashes indicating that it is ready to switch.
(Any outputs currently connected to a selected input will turn white.)
4. Press Output Key 2.
Output Key 2 illuminates indicating that it is ready to accept the switch.
5. Press the Take Key.
Input 1 switches to Output 2, and the keys turn blue.
The panel remains in Change Mode until the Function Key is pressed.
6.
Press Input Key 1 again to toggle it off, and Press the Take Key to disconnect the test switch.

Changing the Virtual Matrix

Enova DGX Switchers support two virtual matrices for switching signals, VM 0 = "All" and VM 1 =
"Video." The system also supports any custom virtual matrices created in XNConnect configuration
software; 2 digits are the maximum allowed (0 through 99). VM 0 is the factory default, and for the
Enova DGX Switcher, VM 0 normally routes the same as VM 1. If you create a custom configuration,
you will need to change the virtual matrix on the Control Panel to execute switches (or other operations)
using the custom virtual matrix.
Note: When audio is embedded on HDMI, the audio switches on the same VM as the video (the
audio and video cannot be switched independently).
The directions below give the steps to change from routing signals on VM 0 to routing on a custom
configuration (VM 2).
To change the virtual matrix:
1.
Press the Function Key.
The Function menu appears.
2.
Locate Virtual Matrix by scrolling with the Control Dial.
3.
Press the Select Key.
The V.Matrix list appears.
116
Current virtual matrix
Current virtual matrix
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers