AMX Enova DGX 8 Instruction Manual page 150

Enova DGX WebConsole Interface
Executing and Disconnecting Switches with the XBar Controller
Note: The VM (virtual matrix) that initially displays in the VM title block is set at the factory to VM 0
(the default). To change the VM, see Step 2 below. To change the initial VM that is displayed every
time you open the XBar, see the directions on page 141. To set the size of the XBar window, see
page 142.
Important: When the BCS tunnel is active, the XBar Controller will not operate.
To execute or disconnect switches on the XBar Controller:
1.
From the IP Control drop-down menu, select Controller.
The XBar Controller opens.
2. Optional (to change the virtual matrix) – Click the VM title block in the upper left corner.
The VM Selection Pad dialog box opens.
FIG. 82
VM Selection Pad


3.
Click a blue (inactive) crosspoint to execute a switch.
The blue crosspoint image turns red as the switch is routed.
Or
Click a red (active) crosspoint to disconnect a switch.
The red crosspoint image turns blue as the switch is disconnected.
Tip: To select or deselect consecutive crosspoints, hold down the Control key and move the mouse
across the desired crosspoints (do not hold down any of the mouse buttons).
When the XBar is used simultaneously by multiple users or when other control options (such as
control panels or external serial controllers) are also being used, system status can be updated from
the VM Selection Pad.
To update system status when using multiple control points:
1.
Click the VM title block in the upper left corner of the XBar.
The VM Selection Pad dialog box opens.
2.
Click Update Status (FIG. 82).
Status of the update is shown in the Operation Progress status bar.
3.
Close the VM Selection Pad when the update is complete.
The most current routing state of the crosspoints is displayed.
144
From the VM drop-down list, select the new virtual matrix.
Close the VM Selection Pad.
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
VM list