AMX Enova DGX 8 Instruction Manual page 98

Enova DGX DXLink™ Twisted Pair Boards
5.
Attach the other end of the second twisted pair cable to the Input (RJ-45) connector on the DXLink
Receiver.
6.
Attach a second HDMI cable to the HDMI Output connector on the Receiver.
7.
Attach the other end of the second HDMI cable to the destination device.
8. Repeat steps above for additional source and destination devices.
9.
If the enclosure is not being used as the source of power, attach the provided desktop power supplies
to the transmitters and receivers.*
10. Apply power to the source and destination devices.
* If the enclosure already has power applied, as soon as transmitters and receivers are connected they
will have power.
Note: DXLink Boards can also work in conjunction with Audio Insert/Extract Boards (see page 101).
DXLink Connector LEDs
The following information applies to the LEDs on the DXLink connectors on the DXLink Input and
Output Boards.
FIG. 48
DXLink connector LEDs (left Enova DGX 32 board orientation; right Enova DGX 8/16 Output Board orientation)


92
Green LED
Yellow LED
Yellow:
On – Authenticated HDCP (handshaking has occurred successfully)

Flashing – Video active; no HDCP

Off – No video

Green:
On – DXLink connection established (between TX or RX and switcher)

Off – DXLink connection not established

Yellow LED Green LED
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers