AMX Enova DGX 8 Instruction Manual page 42

Installation and Setup
FIG. 20
Power setup for complete redundancy on Enova DGX 32
Caution: We recommend attaching all power cords to a surge protector and/or an AC line
conditioner.
Power-Up Sequence
The following instructions start with attaching only two source and destination devices for the purpose
of executing a test switch (after the factory default switch is disconnected).
To apply power:
1.
Attach the first two source and destination devices.
Do not apply power to the source and destination devices until Step 7.


2.
Optional – Attach an external control device/system (see page 52).
36
If connecting devices to DXLink Boards, the boards require DXLink HDMI Transmitters and
Receivers. Install the Transmitters and Receivers between the first two source and/or
destination devices and the DXLink Boards (see "System Setup with DXLink™ Transmitters
and Receivers" on page 82 and the product's documentation).
If connecting devices to SC Optical Boards, the boards require DGX Fiber Modules. Install
the modules for the first two source and/or destination devices and then connect the modules
to the SC Optical Boards (see "System Setup with DGX Fiber Modules" on page 97 and the
module's documentation).
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers