AMX Enova DGX 8 Instruction Manual page 141

A static IP address can also be set without using a DHCP server.
PC Requirements
Windows 7 or Windows XP Professional (32-bit)



To set a static IP address via a terminal program:
1.
Connect a PC to the enclosure via the Program port using a USB to Mini-USB cable.
2. Open a terminal emulation program on the PC.
3.
Set the COM port in the terminal emulation program to a baud rate of 115200.
4.
Power up the system and press the Enter key twice to wake up the port.
5.
Enter echo on (note that this command does not appear on the screen). Press the Enter key.
6. Enter set ip and follow the prompts (see example below).
Set IP Example
In the following example, echo on has been entered but cannot be seen. The characters/numbers in
bold have been entered and appear. The reboot command uses D:P:S notation (Device:Port:System).
set ip
--- Enter New Values or just hit Enter to keep current settings ---
Enter Host Name: master
Enter IP type. Type D for DHCP or S for Static IP and then Enter: DHCP S
Enter IP Address: 192.168.1.101 192.168.1.101
Enter Subnet Mask: 255.255.255.0
Enter Gateway IP: 192.168.1.1
You have entered: Host Name master
Is this correct? Type Y or N and Enter -> Y
Settings written. Device must be rebooted to enable new settings.
>reboot 0:1:0
Important: The reboot updates information between the Enova DGX Master and the server.
The Enova DGX Switcher itself does not reboot.
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Terminal emulation program
USB port
Type Static IP
IP Address 192.168.1.101
Subnet Mask 255.255.255.0
Gateway IP 192.168.1.1
NetLinx® Integrated Control
135