AMX Enova DGX 8 Instruction Manual page 219

5.
Use the tab indicated in FIG. 116 to pull the CPU board straight out of the enclosure.
FIG. 116
Use tab to pull CPU board straight out
6.
Set the Position #1 DIP switch to ON (places the integrated Master into PRD mode).
Note that the DIP switch is mounted with the ON position toward the bottom.
Board guides
FIG. 117
Set Position #1 DIP switch to ON
7.
Slowly slide the CPU board back into the empty slot, being careful to align the edges in the board
guides along the insides (FIG. 117).
8. Push the CPU board into the enclosure firmly enough to make a good electrical connection (avoid
pushing on the connectors). When fully inserted, the faceplate on the CPU board should sit flush
with the back metal.
9.
Reattach the faceplate to the enclosure with the two screws that were removed in Step 3.
10. Plug in both AC power cords.
11. Check the System Status LED on the CPU for indications of normal display (see the table on the
next page).
FIG. 118
System Status LED indicator
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
AC
DC
F L T
System Status LED
Appendix F – Program Run Disable Mode
Tab for removing CPU board
AC
DC
F L T
Normal mode
DIP switch
PRD mode
213