AMX Enova DGX 8 Instruction Manual page 19

CPU/Control Board
RJ-45 ports
System Status indicator
FIG. 6
CPU/Control board
The CPU/Control board is on the left rear of the enclosure, directly below the input connectors.
Each CPU includes the following port and slot options:






Each CPU includes four LED indicators:


* The two Control ports provide direct control of matrix switcher processing (they do not work on the same layer
of control as the integrated Master, which uses the LAN 100/1000 and Program ports).
Power Supply Units
Each of the power supply units on the rear of the enclosure (FIG. 7) has a power receptacle that will
accept all major international standard power sources. (US power cords are included with all shipments
unless ordered otherwise.) Maximum power specifications are provided on the power supply receptacles.
For information on applying power, see page 35.
The power supply units have two LED indicators:


FIG. 7
Power supply receptacles for Enova DGX 8/16 (left) and Enova DGX 32 (right)
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Control (USB mini-B) port
Control (DB-9, RS-232 serial) port
Two RJ-45 ports – for connecting autonomous devices (linking of enclosures is not allowed)
Control port* (DB-9, RS-232) – for attaching an external serial control device (see page 52)
Control port* (USB mini-B) – for attaching an external control device (see page 54)
SD card slot – ships with an installed Micro SD memory card for CPU backup (see page 59)
Program port (USB mini-AB) – for establishing a connection from the Integrated NetLinx Master to
the PC's COM port (see page 40) and for initial setup of the system
LAN 100/1000 port (Ethernet RJ-45) – the connection from the integrated NetLinx Master to a LAN
(see page 41) for all runtime control, NetLinx programming, etc.
System Status LED (to the left of the Control ports)
Status, Output, and Input LEDs (above Program connector) – indicate system communication status
and when data is sent and received (for modes and blink patterns, see page 40)
AC: Green LED – power is good
DC: The DC indicator uses a tri-color LED
Green – power is good

Amber – temperature is above normal

Red – power supply is in a fault state

Enova DGX 8/16 - Indicator LEDs
Product Overview and General Specifications
MAC address
SD card slot
for system status
–
Enova DGX 32 - Indicator LEDs
Program (USB mini-AB) port
and LED indicators
LAN 100/1000 port
13