AMX Enova DGX 8 Instruction Manual page 231

Basic DGX_SHELL Commands (continued)
switch
time
~sysb!
~sysr!
FIG. 125
DGX_SHELL
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
This command graphically displays a matrix switching table 16x16 (8x8 or 32x32) with
outputs on the top and inputs on the left, indicating the routing state of the switches.
Example:
For an example of the matrix switching table showing Input 1 routed to all outputs, see
FIG. 125 at the bottom of this page.
This command displays both run-time clock and system time information.
Usage: time{-r|-s <seconds>}
-r resync the system clock with real time clock
-s <epoch_seconds> set the real time clock to UTC in seconds from epoch (1 Jan 1970)
The time is displayed in epoch (unix) time.
Example of response:
rtctime: Tue, 28 Mar 2012 15:27:45 UTC last updated: Thu, 01 Jan 1970 00:00:00 UTC
systime: Thu, 29 Mar 2012 12:51:11 UTC last updated: Thur, 29 Mar 2012 12:47:52 UTC
Note: For time conversion information, see http://www.epochconverter.com.
This command is used to save (backup) system configuration settings from the SD card.
For additional information on the SD card, see page 59. (This command is also a BCS alias
command.)
Alias: config save
This command is used to restore system configuration settings to the SD card. For additional
information on the SD card, see page 59. (This command is also a BCS alias
command.)
Alias: config restore
switch
command displays matrix switching status in a table (Enova DGX 16 shown)
Appendix H – DGX_SHELL Commands
225