AMX Enova DGX 8 Instruction Manual page 43

3.
Plug power cords into both of the power receptacles on the enclosure.
FIG. 21
Attach power cables to both power receptacles (Enova DGX 8/16 shown)
FIG. 22
Attach power cables to both power receptacles (Enova DGX 32 shown)
4.
Plug the other end of each power cord into a power strip(s) that is turned off (we recommend using a
20 A circuit breaker on a 110 circuit for fully loaded enclosures).
5.
Turn on the power strip and wait 30 seconds.
The Power indicator LED on the Control Panel illuminates green (showing that both redundant power
supplies are working). If only one power supply is working, the Power indicator will illuminate a
constant red (check power connections and switches).
The LCD on the Control Panel illuminates and displays the menu screen.
6. Optional – Apply power to a control device/system.
7.
For systems with SC Optical Boards – Apply power to the DGX TX and RX Fiber Modules.
8.
Apply power to the source and destination devices.
9.
Disconnect the factory default switch and execute a test switch (see page 49).
10. Attach the remaining sources and destinations and apply power to them.
Important: Whenever the system is powered down, be sure the indicator LEDs on the CPU are off
and the fans have stopped before reapplying power.
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Enova DGX 8/16 power supplies
Enova DGX 32 power supplies
Installation and Setup
37