Installation And Setup; Ul Safety Certifications, Notices, And Recommendations For Laser Products - AMX Enova DGX 8 Instruction Manual

Installation and Setup

Important: If the Enova DGX Switcher contains Epica DGX SC Optical Boards, be sure to read all of
the safety information for laser products in this chapter and in the SC Optical Board chapter.

UL Safety Certifications, Notices, and Recommendations for Laser Products

Per UL requirements, make note of the following:




Since the class of radiation emitted from the fiber port can be Class 3R when the fiber cable or dust plug
is removed, a yellow and black label with the following caution is located on the rear of the enclosure.
FIG. 12
Caution label for Class 3R laser products
Important: No user serviceable parts are included inside Enova DGX Switchers; service should only
be done by qualified personnel.
Caution: Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
Exercise caution when installing DGX Fiber products to avoid direct eye exposure to invisible laser
radiation. Follow the recommendations below whenever installing or working with DGX Fiber products.
 
 
 
 
 
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
The DGX SC Optical Boards comply with IEC Standard: IEC 60825-1, 2001.
The boards also comply with 21 CFR 1040.10 and 1040.11 except for deviations pursuant
to Laser Notice No. 50, dated June 24, 2007.
The DGX SC Optical Output (TX) Boards are CLASS 1 LASER PRODUCTS.
The maximum output power of the laser radiation is 4.08 mW.
Be sure to apply the power only after all fiber connections are made and no fiber ends are
exposed.
Do not remove dust plugs from SC fiber connectors or the dust caps from the fiber cables until
establishing connections; avoid direct eye exposure.
Make sure all cables, including fiber cables, are correctly connected and/or terminated.
Before you unplug a fiber cable on an input board, disconnect the power on the DGX TX that is
connected to the input.
Before you unplug a fiber cable on an output board, disconnect the switch for that output
connector.
Installation and Setup
25