AMX Enova DGX 8 Instruction Manual page 97

Twisted Pair Cable Pinouts
Use either the T568A or T568B pinout specification for termination of the twisted pair cable used
between the Transmitter or Receiver and the enclosure.
FIG. 46
Twisted pair cable pinouts for T568A and T568B
Important: Twisted pair cable quality required in order to reach 100 meter distance should meet
ANSI/TIA/EIA 568A-5 or better specification and be rated for 250 MHz or better.
To connect sources and destinations to DXLink inputs and outputs via TX/RX:
1.
Attach an HDMI cable from the source device to the HDMI connector on the DXLink Transmitter.
2. Attach a twisted pair cable to the DXLink Transmitter's Output (RJ-45) connector.
3.
Attach the other end of the twisted pair cable to the input connector on the DXLink Input Board.
FIG. 47
Fasten cables onto input and output connectors
4.
Attach a second twisted pair cable to the output connector on the DXLink Output Board.
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
Enova DGX DXLink™ Twisted Pair Boards
91