AMX Enova DGX 8 Instruction Manual page 63

9.
In the AutoPatch USB Bridge Properties dialog box, select the General tab.
10. Make note of the COM port number assigned to the AutoPatch USB Bridge. This port number must
be entered when setting a connection in a software program or a terminal emulation program. The
PC will always associate a specific USB connector with the assigned virtual COM port. The PC will
not recognize the module if you disconnect and reconnect using a different COM port on the PC.
However, it will attempt to install a new virtual COM port using the new port. If completed, the new
port will be assigned a different COM number.
Important: You must identify the virtual COM port assigned to the USB connector to enable
communication between the Control PC and the switcher.
11. Set up and run the desired application:


12. Execute a test switch to make sure the Enova DGX Switcher is working properly (see page 49).
Important: If power is cycled on the enclosure, the USB connection must be reestablished.
(1) Remove the USB cable, (2) close the software application in use, (3) reconnect the USB cable
to the same USB connector that was used previously, and (4) reopen the communication software.
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
AMX Controller – For control programming information, see the instruction manual for the
specific interface.
Terminal Emulation – Open the program (see "Terminal Emulation" below). Check to be
sure the COM port is set for the port determined in the previous steps. Set the settings to
match the default ones: baud rate – 9600, data bits – 8, parity – 1, stop bits – none, and
flow control – 1.
Installation and Setup
Assigned port number
57