AMX Enova DGX 8 Instruction Manual page 37

3.
Audio Insert/Extract Boards only – Remove the boards (see page 105) and set the DIP switches to
either insert or extract audio (see page 105). This is the only mechanism for configuring the insert/
extract functionality.
Caution: On systems with SC fiber connectors, we recommend using the provided cable
management bars or some other type of cable management system to avoid damage to the fiber
cables.
4. Recommended for SC Optical – Attach the provided cable management bars to the input and output
boards (see page 32).
5. Attach only the first two source and destination devices.




6.
Attach power cords to both power receptacles on the enclosure, then turn on the entire system
(see page 35).* We recommend using a surge protector and/or an AC line conditioner.
7.
Set up the system using the integrated NetLinx Master (see page 39):
8.
Disconnect the factory default switch and execute a test switch to make sure the system is working
properly (see page 49).
9.
When the test switch works correctly, attach the remaining source and destination devices and any
additional DXLink HDMI or DGX Fiber Transmitters and Receivers. If applicable, wire remaining
connectors on the Audio Insert/Extract Board(s).
* Power Budget Planning – If the system contains DXLink Boards, be sure to read the section on Power
Budget Planning on page 88. The power draw for the system should be calculated in order to maintain
the power redundancy of the power supplies in the enclosure. Calculating the power draw also helps
determine how many DXLink Transmitters and Receivers can be powered via the switcher.
Special Information for HDMI and DVI Boards
If the system contains HDMI and/or DVI Boards, configuration of the boards may be necessary.
DGX Configuration Software is available for configuring the boards (see page 157). This software is
available at www.amx.com.
Special Information for the Audio Insert/Extract Board
If the system contains Audio Insert/Extract Boards, the connector default settings may need to be
changed for insertion and extraction of audio, see page 105.
Instruction Manual – Enova DGX 8/16/32 Digital Media Switchers
If connecting devices to HDMI or DVI Boards, see the special information for these boards
below.
If connecting devices to DXLink Boards, the boards require DXLink HDMI Transmitters and
Receivers. Install the Transmitters and Receivers between the first two source and destination
devices and the DXLink Boards (see "System Setup with DXLink™ Transmitters and
Receivers" on page 82 and the product's documentation).
If connecting devices to SC Optical Boards, the boards require DGX Fiber Modules. Install
the modules between the first two source and/or destination devices and the SC Optical
Boards (see "System Setup with DGX Fiber Modules" on page 97 and the modules'
documentation).
If wiring devices to an Audio Insert/Extract Board(s), see page 101.
Installation and Setup
31