Table of Contents
Advertisement
Chapter 5: Verifying the Hardware Operations
Verifying the Switch with the AlliedWare Plus Commands
134
To confirm the hardware operations of the switch with the AlliedWare Plus
Operating System, perform the following procedure:
1. Start a local management session on the switch. For instructions, refer
to "Starting a Local Management Session" on page 127.
2. To display the status of the power supplies and fan modules, enter the
SHOW SYSTEM ENVIRONMENT command in the User Exec or
Privileged Exec mode. The Status column in the display provides the
states of the modules. Components are operating normally when they
have an "Ok" status.
The next command, SHOW CARD, has to be performed from the
Privileged Exec mode. If you are still in the User Exec mode, enter the
ENABLE command to move to the Privileged Exec mode. The mode
prompt is "awplus#".
3. To display the status of the line cards, enter the SHOW CARD
command in the Privileged Exec mode. A line card has a state of
"Online" when it is operating normally. An example of the status
information is shown in Figure 96 on page 134.
awplus# show card
Slot
Card Type
---------------------------------------------------
1
XEM2-12XT
2
XEM2-12XT
3
XEM2-12XTm
4
XEM2-12XS
5
XEM2-12XS
6
XEM2-1CQ
7
XEM2-4QS
8
XEM2-4QS
Figure 96. SHOW CARD Command
4. To display the states of the individual ports on the Ethernet line cards,
use the SHOW INTERFACE STATUS command in the Privileged
Exec mode.
For information about the command line interface, refer to the
Software Reference for SwitchBlade x908 GEN2 Series Switches on
the Allied Telesis web site.
5. Go to Chapter 6, "Cabling the Networking Ports" on page 135.
State
Online
Online
Online
Online
Online
Online
Online
Online
Advertisement
Table of Contents
