Verifying The Switch With Alliedware Plus Commands; Figure 97: Show Card Command - Allied Telesis AT-SB*908 GEN2 Installation Manual

Chapter 6: Configuring Switches for Stacking

Verifying the Switch with AlliedWare Plus Commands

148
Now that you have installed the switch and powered it on for the first time,
you should verify that the hardware components are operating normally.
The following procedure show how to do this using commands in the
AlliedWare Plus operating system. To verify the hardware operations of
the switch, perform the following procedure:
1. Start a local management session on the switch. Refer to "Starting a
Local Management Session" on page 145.
2. To display the status of the power supplies and fan modules, enter the
SHOW SYSTEM ENVIRONMENT command in the User Exec or
Privileged Exec mode. The Status column in the display provides the
states of the modules. Components are operating normally when they
have an "Ok" status.
The next command, SHOW CARD, has to be performed from the
Privileged Exec mode. If you are still in the User Exec mode, enter the
ENABLE command to move to the Privileged Exec mode. The mode
prompt is "awplus#".
3. To display the status of the line cards, enter the SHOW CARD
command in the Privileged Exec mode. Line cards are operating
normally when their status are "Online." Figure 97 is an example.
awplus# show card
Slot Card Type
---------------------------------------------------
1 AT-XEM2-12XT
2 AT-XEM2-12XT
3 AT-XEM2-12XT
4 AT-XEM2-12XS
5 AT-XEM2-12XS
6 AT-XEM2-1CQ
7 AT-XEM2-4QS
8 AT-XEM2-4QS
Figure 97. SHOW CARD Command
4. To display the states of the individual ports on the Ethernet line cards,
use the SHOW INTERFACE STATUS command in the Privileged
Exec mode.
For information about the command line interface, refer to the
Software Reference for SwitchBlade x908 GEN2 Series Switches on
the Allied Telesis web site.
5. Go to "Viewing the AlliedWare Plus Version Number" on page 149.
State
Online
Online
Online
Online
Online
Online
Online
Online