Verifying The Switch With Alliedware Plus Commands - Allied Telesis x950 Series Installation Manual

Verifying the Switch with AlliedWare Plus Commands

Now that the switch is powered on, use the SHOW SYSTEM
ENVIRONMENT command in the AlliedWare Plus operating system to
verify that the hardware components are operating correctly. To verify the
hardware operations, perform the following procedure:
1. Start a local management session on the switch. Refer to "Starting a
Local Management Session" on page 119.
2. Enter the SHOW SYSTEM ENVIRONMENT command in the User
Exec or Privileged Exec mode.
3. Check the Status column. All components should have the status
"OK."
For information about the command line interface, refer to the Software
Reference for AT-x950 Switches on the Allied Telesis web site.
4. Go to "Disabling VCStack" on page 122.
x950 Series Installation Guide for Stand-alone Switches
121